Three Basic Globe Valve Body Designs

Update:06-03-2020
Summary:All globe valves are designed with a stem that moves up and down to regulate flow inside the valve, contains a disc (bal...

All globe valves are designed with a stem that moves up and down to regulate flow inside the valve, contains a disc (ball, composition, or plug), and seat which is generally screwed into the valve body. Seats are designed in plane parallel or inclined to the line of the flow.

There are three basic globe valve body designs: Tee, Angle, and Wye.

Tee

This is the most common body type for a globe valve. The horizontal setting of the seat allows the stem and disk to travel perpendicular to the horizontal line. This design has the lowest coefficient of flow and highest pressure drop. They're used in severe throttling services, such as in bypass lines around a control valve. When pressure drop is not a concern and throttling is required, this globe valve design is a good solution.

Angle

The ends of this globe valve are at a 90° angle allowing fluid to flow in a single 90° turn. This valve is used for applications that have periods of pulsating flow because of their ability to handle "the slugging effect" which naturally occurs with a pulsating flow.

Wye

This type is an alternative for the high pressure drop commonly found in globe valves. The seat and stem are at a 45° angle which provides a straighter flowpath when fully open and offers the least resistance of flow. This design is commonly used for throttling during seasonal or start-up operations.